eFLO

eFlo - electronic flow meter

eFlo is an electronic flow measurement instrument used to display and control the flow of gases. With simple compatibility with existing controls, tracking an monitoring gas flows has never been easier. Designed for use in the harshest industrial enviroments.

eFlo allows for easy replacement of manual flow meters and seamlessly integrates into existing control systems.

Benefits

  • Available with electronic valve, manual valve, and without control valve
  • Digital display with easy-to-use touch pad
  • Precision flow measurement
  • Direct and remote setpoint control
  • Utilizes Flo Meter View software
  • Flow calibration can be certified while in use to meet CQI-9 requirements
  • NIST - traceable calibration
  • SCADA Integration: Current Flow, Totalized Flow, Setpoint, Cost Calculation
  • Built-in high/low flow alarms
  • Analog control and feedback for data acquisition
  • Integrated comms via Modbus over RS232/RS285
Indicator LEDs
Tactile Keypad
Process Data Display Totalizer - Aggregate flow from last reset
Alarm (Hi/Low) Reset
Auto/Manual Setpoint
Open/Close Auto/Manual
Motor Drive Setup - Configuration

 

eFlo Part Number

14 Valve Type
Gas Type
   
Flow Meter

A = Automatic (Electronic) Valve

Acetylene Endothermic Gas (C3H8) Methane
 

M = Manual (Non-Electronic) Valve

Air Endothermic Gas (CH4) Natural Gas
 

X = Fixed Flow / No Valve

Ammonia Ethane Neon
    Argon Ethylene Nitrogen
    Butane Exothermic Gas Nitrous Oxide
    Carbon Dioxide Helium Oxygen
    Carbon Monoxide Hydrogen Propane
    Chlorine Hydrogen Chloride Sulfur Dioxide
    Dissociated Ammonia Hydrogen Sulfide  

 

Specifications

Pwer Required 24V @ 400mA
Accuracy +/- 4%
Turndown Ratio 6:1
Gas Temperature Limits 32°F to 150°F (0°C bis 65,6°C)
Ambient Temperature Limits 32°F to 150°F (0°C bis 65,5°C)
Flo Output Signal (Linear) 4 - 20mA
Max. Output Signal Load 500 Ohm
Input Control Signal (Linear) 4 - 20mA
Response Time 1 - 10 seconds
Communications RS232, RS485
Communications Protocol Modbus RTU
Flow Meter Pressure Limits 5 PSI max (Standard)